Mercedes S-Class W-140

1991-1999 of release

Repair and car operation


Mercedes S-Class
+ Mercedes-Benz Cars of a class S (W-140)
+ Operation manual
+ Routine maintenance
+ Engine
+ Systems of cooling, heating
- Power supply system and release
   + the Power supply system and injection of fuel of the petrol engine - the general information
   + System of injection of fuel of the diesel engine - the general information
   - Control system of injection of fuel and HFM-SFI ignition (6-cylinder petrol engines)
      Removal and installation of injectors
      Replacement of the sensor of measurement of an air stream (except the M104.990 engine)
      Removal and installation of a diafragmenny regulator of pressure of fuel (except the engine M 104.990)
      Removal and installation of the air pump
      Removal and installation of the sensor of provision of a cranked shaft (CKP)
      Removal and installation lambda probe
      Removal and installation of sensors of a detonation
   + Control systems of the LH-SFI and ME-SFI engine (8-cylinder petrol engines)
   + Control systems of injection of fuel and ME-SFI and LH-SFI ignition (12-cylinder petrol engines)
   + Control system of fuel injection (diesel engines of the Om603.971 series)
   + Control system of fuel injection (diesel engines of the Om606.961 series)
   + turbo-supercharging System - the general information
   Systems of decrease in toxicity of release - the general information
   System of production of the fulfilled gases - the general information
   Catalytic converter (petrol models)
+ engine Electric equipment
+ gear shifting Box
+ Avtomaticheckaya transmission
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


56822268


Control system of injection of fuel and HFM-SFI ignition (6-cylinder petrol engines)

Removal and installation of the fuel distributive highway with injectors

Removal

Injectors

16/7 — the Clamp
16/8, 16/9 — Sealing rings
Y62 — the Injector


 PERFORMANCE ORDER

1. Remove an airintaking pipe.
2. Dump pressure of fuel in the distributor.
3. Remove the oil filter (only on M104 series engines with the integrated oil radiator).
4. Remove the fuel distributive highway. Replace sealing rings of landing of injectors (16/8).
5. Unscrew forcing and returnable pipelines.

Installation

Installation is made as it should be, the return to removal.







QX4.ONLINE
S40.ONLINE
A-8.ONLINE
W124.ONLINE
RX300.ONLINE
W140.ONLINE
B3-B4.SPACE
B3B4.SPACE
A-8.SPACE