| 1. Establish doors on aligning bolts, having at the same time inserted pneumatic lines and electroconducting through a forward rack. |
|
| 2. Wrap bolts and tighten them the moment of 37 Nanometers.
|
|
| 3. Attach or weaken a protective sleeve and a door clamp to a forward rack. |
|
| 4. Attach all conducting of a door of the driver to the conducting socket in a floor and fix them a fixing tape. Establish the panel on a floor. Remove an emphasis of a door and check a gap between a door and a body, adjust it if it is necessary. |
|
| 5. Wrap bolts of fastening of an emphasis of a door, but do not tighten them. |
|
| 6. Adjust the provision of a door of the driver so that the panel was aflush with a forward wing or is lower on 1 mm. Check adjustment of a back door. |
|
| 7. Adjust a door emphasis so that the door was completely closed, and adjust a door, moving an emphasis so that the door was flush with a back door or on 1 mm is higher. |
|
| 8. Tighten bolts of fastening of an emphasis of a door the moment of 20 Nanometers.
|
| 9. Check a contour of a door and establish a window frame. Check a door on ease of moving. |
|
