Mercedes S-Class W-140

1991-1999 of release

Repair and car operation

Mercedes S-Class
+ Mercedes-Benz Cars of a class S (W-140)
+ Operation manual
+ Routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ gear shifting Box
+ Avtomaticheckaya transmission
- Coupling
   + Coupling
   - Power shafts
      Removal and installation of a flange of a power shaft and radial and persistent ball bearing
      Removal, check and installation of a power shaft
      Removal and CV JOINT installation of power shafts and their protective covers
   + Differential
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


Power shafts

General information

The car is actuated by means of torque transfer from a transmission to wheels by means of two power shafts of different length. The right shaft consists of two parts. Boots of internal hinges are made of rubber, and external - from thermoplastic (thermoplastic is steadier against external influences).

Each shaft consists of three main parts: internal tripodny hinge, directly shaft and external hinge of equal angular speeds (CV JOINT). The internal hinge of the left shaft is fixed in a box with the help of a lock ring. The internal hinge of the right shaft is established in specially intended nest of an intermediate shaft.

The intermediate shaft, in turn, enters into the bearing located in a box, and is fixed by means of an arm attached to the back party of the block of cylinders. External hinges of both shaft (CV JOINTS) terminate in shlitsevy shaft which enter into shlitsevy naves of driving wheels. Shaft are fixed in naves by nuts.