Mercedes S-Class W-140

1991-1999 of release

Repair and car operation

Mercedes S-Class
+ Mercedes-Benz Cars of a class S (W-140)
+ Operation manual
+ Routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ gear shifting Box
+ Avtomaticheckaya transmission
- Coupling
   + Coupling
   Driveshaft
   - Power shafts
      Removal and installation of a flange of a power shaft and radial and persistent ball bearing
      Removal, check and installation of a power shaft
      Removal and CV JOINT installation of power shafts and their protective covers
   + Differential
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and installation of a flange of a power shaft and radial and persistent ball bearing

Removal

Flange of a power shaft and radial and persistent ball bearing

PERFORMANCE ORDER

1. Remove a power shaft.
2. Remove a brake disk.
3. Remove blocks of lay brake system.
4. Take a flange of a power shaft (10) (at the established support of a wheel).
5. Remove a lock ring (9).
6. Remove the radial and persistent ball bearing (8) from a wheel support.
7. Take an internal ring of the bearing from a flange of a power shaft.

Check

Check axial and radial palpation of a flange (10) power shafts. The limiting admissible size axial люфта a flange makes 0.03 mm, radial palpation - also 0.03 mm.

Installation

Installation is carried out as it should be, the return to removal.

Flange of a power shaft

Removal

Removal of a flange of a power shaft

PERFORMANCE ORDER

1. Insert a carving bolt (010j) into a flange (10) outside and tighten it to an arm (010g). 2. Establish a basic plate (010d) on a wheel support.
3. Establish a clamping plate (010f) with a clamping bolt (010b) through an arm and establish again on a basic plate (010d).
4. Establish a hydraulic press (010h) between persistent laying (010f) and an arm (010g). Unscrew clamping a bolt (010k) from a hydraulic press, then a bolt (010i) an arm until it will not concern the clamping cylinder of a hydraulic press.
5. Screw clamping a bolt (010k) a hydraulic press (the maximum moment of 40 Nanometers) until the flange of a power shaft will not be removed).
6. Strike with a hammer on an arm (shooter).
7. If it will be insufficiently, turn out a bolt (010i) from an arm.

Installation

Installation of a flange of a power shaft


7 — a wheel Support 8 — Dvukhryadny the radial and persistent ball bearing

Establish a flange (10) on the dvukhryadny radial and persistent ball bearing (8), using the adjusting tool (08а) - (08с), (08е) - (08i). Be convinced that the small clamping plate (08с) is correctly established on an internal ring of the bearing (shooter).

Dvukhryadny, radial and persistent ball bearing

Removal of the dvukhryadny radial and persistent ball bearing


7 — a wheel Support 08 — Dvukhryadny the radial and persistent ball bearing 08а — the Bolt with a nut 08b — the Stripper 08с — Persistent laying (small)

Installation of the dvukhryadny radial and persistent ball bearing


7 — a wheel Support 8 — Dvukhryadny the radial and persistent ball bearing 08а — the Bolt with a nut 08b — the Stripper 08с — Persistent laying (small) 08е — Clamping the bearing