Mercedes S-Class
+ Mercedes-Benz Cars of a class S (W-140)
+ Operation manual
+ Routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ gear shifting Box
+ Avtomaticheckaya transmission
+ Coupling
- Brake system
Specifications
Arrangement of components of antiprobuksovochny system ASR/ETS
Arrangement of components of the amplifier of emergency braking (BAS)
Arrangement of components of ESP system
Dismantling and assembly of the main brake cylinder (GTTs) of the Tandem type (model 140.028/032/033/135)
Removal, installation and check of serviceability of functioning of the servo-driver of the vacuum amplifier of brakes
Removal and installation of a brake support
Check of thickness of a brake disk and overlays of brake shoes
Removal and installation of blocks of the parking brake
Removal and installation of a forward cable of a drive of the parking brake
Adjustment of the parking brake
Wheel ABS sensors - installation details
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal, installation and check of serviceability of functioning of the servo-driver of the vacuum amplifier of brakes
Removal Details of installation of the servo-driver of the vacuum amplifier of brakes
|
|
|
1. Remove the main brake cylinder (see. Section Dismantling and assembly of the main brake cylinder (GTTs) of the Tandem type (model 140.028/032/033/135)).
2. Remove supporting pump ASR.
3. Check GTTs on absence of damages and leaks.
4. Turn on or unhook a vacuum tube (8) from the vacuum amplifier (16). Press several times a brake pedal to reduce pressure in the vacuum amplifier.
5. Disconnect the socket (A7/7kh1), (A7/7kh2) from the BAS control unit or on models with ESP disconnect the socket from the switch of the electromagnetic valve and the sensor of moving of a diaphragm of BAS on the vacuum amplifier. On models with BAS and ESP, the BAS control unit it is integrated with the ESP control unit.
6. Remove the bottom cover of the dashboard.
7. Disconnect a returnable spring of a brake pedal.
8. Take a clamp and a finger (26).
9. Unscrew a nut (23) from an arm (22).
10. Remove the vacuum amplifier (16).
11. Check laying (16). |
|
Installation Installation is carried out as it should be, the return to removal.
Check
|
|
1. Press a pedal of a brake to reduce pressure in the vacuum amplifier.
2. Disconnect a tester from the vacuum amplifier. |
3. Attach a manometer (051) to a brake support with an adapter.
4. Attach the sensor of measurement of effort to pedals (06) on a brake pedal. |
|
5. Get the engine and create pressure 0.75 - 0.80 bar, pressing and releasing an accelerator pedal. If will reach vacuum on value much below, than it is required, or the vacuum immediately decreases, the sealing ring between the vacuum amplifier and the main brake cylinder is damaged or it is necessary to check the valve in a vacuum tube.
6. Create demanded effort to pedals of an accelerator and read pressure in the line. Dependence of pressure in a hydraulic actuator from effort of pressing to a pedal of a foot brake is given in Specifications. |
|
|
|
