Mercedes S-Class W-140

1991-1999 of release

Repair and car operation



Mercedes S-Class
+ Mercedes-Benz Cars of a class S (W-140)
+ Operation manual
+ Routine maintenance
+ Engine
+ Systems of cooling, heating
- Power supply system and release
   + the Power supply system and injection of fuel of the petrol engine - the general information
   + System of injection of fuel of the diesel engine - the general information
   - Control system of injection of fuel and HFM-SFI ignition (6-cylinder petrol engines)
      Removal and installation of injectors
      Replacement of the sensor of measurement of an air stream (except the M104.990 engine)
      Removal and installation of a diafragmenny regulator of pressure of fuel (except the engine M 104.990)
      Removal and installation of the air pump
      Removal and installation of the sensor of provision of a cranked shaft (CKP)
      Removal and installation lambda probe
      Removal and installation of sensors of a detonation
   + Control systems of the LH-SFI and ME-SFI engine (8-cylinder petrol engines)
   + Control systems of injection of fuel and ME-SFI and LH-SFI ignition (12-cylinder petrol engines)
   + Control system of fuel injection (diesel engines of the Om603.971 series)
   + Control system of fuel injection (diesel engines of the Om606.961 series)
   + turbo-supercharging System - the general information
   Systems of decrease in toxicity of release - the general information
   System of production of the fulfilled gases - the general information
   Catalytic converter (petrol models)
+ engine Electric equipment
+ gear shifting Box
+ Avtomaticheckaya transmission
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment



56822268


Removal and installation lambda probe

Lambda probe (the oxygen sensor) it is established in system of production of the fulfilled gases and it is equipped with the built-in electroconducting terminating in the contact socket, - try not to allow electroconducting damages at sensor removal.

Carefully wipe a sensor surface without application of any solvents. At engine temperature less 48°С the reversing of the sensor can occur to difficulty.

Before a sensor vvorachivaniye into place do not forget to grease its carving part with anti-taking hermetic. Track, that the tightening of the sensor was made with demanded effort.