Mercedes S-Class W-140

1991-1999 of release

Repair and car operation



Mercedes S-Class
+ Mercedes-Benz Cars of a class S (W-140)
+ Operation manual
+ Routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ gear shifting Box
+ Avtomaticheckaya transmission
+ Coupling
+ Brake system
- Suspension bracket and steering
   Security measures
   Corners of installation of wheels of the car, road clearance
   + Forward suspension bracket
   + Back suspension bracket
   - Steering
      Removal and installation of the steering pump (model with engines 104, 119, 120 and 606)
      Dismantling and assembly of the pump of the amplifier of a steering
      Dismantling and assembly of an electronic and adjustable steering column
      Removal and installation of the bottom steering shaft
      Removal and installation of a drive of telescopic adjustment of a steering column
      Removal and installation of an emphasis of a pipe
      Dismantling and assembly of an internal pipe
      Installation of the top arm of fastening of a pipe (model to identification number 123446)
      Installation of the top arm of fastening of a pipe (model from identification number 123447)
      Removal and installation of the blocking cylinder (model till 31.08.95 вып.)
      Removal and installation of the blocking cylinder (model since 1.09.95 вып.)
      Contact spring
      Removal and installation of average steering draft
      Removal and installation of the pendular lever of a steering drive
      Removal and installation of cross-section steering draft
+ Body
+ Onboard electric equipment



56822268


Removal and installation of the blocking cylinder (model since 1.09.95 вып.)

Removal and installation of the blocking cylinder (model 140 since 1.09.95 вып.)

Removal

 PERFORMANCE ORDER

1. Remove the lock of blocking of a steering shaft, remove the protective plug (36d) from the blocking lock.
2. Press a rack (shooter) and take the lock of ignition (S2/1) with the lock of blocking of a steering shaft from the protective plug (36d). The blocking cylinder (36) can be replaced together with the protective plug (36d) and a cover (36b). On models from AT the valve of blocking of a parking (37h) too settles down on the lock of ignition (S2/1).

Installation

 PERFORMANCE ORDER

1. Turn the blocking cylinder (36) in situation "1" by means of a key (36c) and press the new plug (36d) until the blocking doggie (36h) will not be blocked in the necessary situation.
2. Take a key.
3. Establish a cover (36b) on the protective plug so that the lock ring (36g) was blocked in the necessary situation.
4. Press the lock of ignition (S2/1) with blocking shaft in the protective plug (36d) so that it was blocked in the necessary situation.