Mercedes S-Class W-140

1991-1999 of release

Repair and car operation

Mercedes S-Class
+ Mercedes-Benz Cars of a class S (W-140)
+ Operation manual
+ Routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ gear shifting Box
+ Avtomaticheckaya transmission
+ Coupling
+ Brake system
- Suspension bracket and steering
   Security measures
   Corners of installation of wheels of the car, road clearance
   + Forward suspension bracket
   + Back suspension bracket
   - Steering
      Removal and installation of the steering pump (model with engines 104, 119, 120 and 606)
      Dismantling and assembly of the pump of the amplifier of a steering
      Dismantling and assembly of an electronic and adjustable steering column
      Removal and installation of the bottom steering shaft
      Removal and installation of a drive of telescopic adjustment of a steering column
      Removal and installation of an emphasis of a pipe
      Dismantling and assembly of an internal pipe
      Installation of the top arm of fastening of a pipe (model to identification number 123446)
      Installation of the top arm of fastening of a pipe (model from identification number 123447)
      Removal and installation of the blocking cylinder (model till 31.08.95 вып.)
      Removal and installation of the blocking cylinder (model since 1.09.95 вып.)
      Contact spring
      Removal and installation of average steering draft
      Removal and installation of the pendular lever of a steering drive
      Removal and installation of cross-section steering draft
+ Body
+ Onboard electric equipment

Removal and installation of a drive of telescopic adjustment of a steering column

Removal

PERFORMANCE ORDER

1. Unscrew a bolt (84) and take a telescopic drive (М20m1).
2. Remove the blocking device (84b) and take a finger (84a) from an external pipe (81a). 3. Remove a telescopic drive of adjustment (М20m1).

Installation

PERFORMANCE ORDER

1. Establish a telescopic drive (М20m1) on an external pipe (81a) and insert a finger (84a). 2. Fix the blocking device (84b).
3. Using the indicator (22), adjust a pipe gap. For this purpose move a telescopic drive (М20m1) and a bolt (84) to an oblong opening so that the gap was reached. The gap should be within 0.25 - 0.30 mm.
4. Tighten a bolt (84).

QX4.ONLINE
S40.ONLINE
A-8.ONLINE
W124.ONLINE
RX300.ONLINE
W140.ONLINE
B3-B4.SPACE
B3B4.SPACE
A-8.SPACE