Mercedes S-Class W-140

1991-1999 of release

Repair and car operation

Mercedes S-Class
+ Mercedes-Benz Cars of a class S (W-140)
+ Operation manual
+ Routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ gear shifting Box
+ Avtomaticheckaya transmission
+ Coupling
+ Brake system
- Suspension bracket and steering
   Security measures
   Corners of installation of wheels of the car, road clearance
   + Forward suspension bracket
   + Back suspension bracket
   - Steering
      Removal and installation of the steering pump (model with engines 104, 119, 120 and 606)
      Dismantling and assembly of the pump of the amplifier of a steering
      Dismantling and assembly of an electronic and adjustable steering column
      Removal and installation of the bottom steering shaft
      Removal and installation of a drive of telescopic adjustment of a steering column
      Removal and installation of an emphasis of a pipe
      Dismantling and assembly of an internal pipe
      Installation of the top arm of fastening of a pipe (model to identification number 123446)
      Installation of the top arm of fastening of a pipe (model from identification number 123447)
      Removal and installation of the blocking cylinder (model till 31.08.95 вып.)
      Removal and installation of the blocking cylinder (model since 1.09.95 вып.)
      Contact spring
      Removal and installation of average steering draft
      Removal and installation of the pendular lever of a steering drive
      Removal and installation of cross-section steering draft
+ Body
+ Onboard electric equipment


Removal and installation of average steering draft



1. Disconnect the dempferny shock-absorber (46) from average steering draft (11).
2. Holding an axial bolt, give nuts of fastening of average bent for to a steering soshka and the pendular lever. By means of an opravka (051) No. 140 589 0063 00 and a stripper (053) No. 140 589 00 33 00 separate draft (11) from a soshka and the lever.



1. Installation is made upside-down. Track reliability of fastening of spherical hinges of the longitudinal lever. Replace самоконтрящийся fixture (it is tightened with effort of 50 Nanometers). At connection to draft of the dempferny shock-absorber tighten fixture with effort of 40 Nanometers.
2. Check corners of installation of forward wheels, in case of need make the corresponding adjustment.