Mercedes S-Class
+ Mercedes-Benz Cars of a class S (W-140)
+ Operation manual
+ Routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ gear shifting Box
- Автоматичеcкая transmission
Specifications
Search of malfunctions - the general information
- Automatic transmission 722.5
Removal, check of a condition and installation of the converter of rotation (hydrotransformer)
Removal and installation of a centrifugal regulator
Removal and installation of the sensor switch of blocking of a starter (start permission)
Vacuum knot - installation details
Removal, service and installation of the secondary pump (AT to No. 3652931)
Removal and installation of a forward cover with the secondary pump
Removal and LB3 piston installation
Removal and installation of a back cover of transmission
Dismantling and assembly of klapanny assembly of AT
Dismantling and transmission assembly
Installation and gap check in multidisk brake В3
Gap measurement in brake В1
Coupling of raising transfer
Removal, installation and check of components of a brake of BS of raising transfer and KS coupling
Dismantling and assembly of the coupling of a free wheeling
Dismantling and assembly of planetary mechanisms
Dismantling and assembly of coupling К1
Coupling К2
Lever of the selector of gear shifting
+ Automatic transmission 722.6
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal, check of a condition and installation of the converter of rotation (hydrotransformer)
Removal
|
|
| 1. Establish a transmission the rotation converter up. |
2. Turn a plastic finger of the converter of rotation on 1/4 turns counter-clockwise.
3. Tighten handles (065) on the rotation converter |
|
| 4. Take the rotation converter. |
|
Check
The case of the converter of rotation has the following nominal overall dimensions:
| Diameter, mm |
270
|
| Height, mm |
| New assembly |
120.7
|
| Maximum permissible value |
121.5
|
|
|
|
1. Establish the rotation converter assembled with the secondary pump a leading flange up on a measuring plate (05).
2. Measure dimensional height of "A" of the case of the converter of rotation. If the result of measurement exceeds limiting admissible value, replace the converter. |
|
|
Installation
|
|
| 1. Grease a flange (32) means of Molykote. |
|
2. Establish a plastic finger and turn it on 1/4 turns clockwise.
3. Unscrew handles (065) from the rotation converter. |
|
| 4. By means of a calliper measure size of a vystupaniye of "A" of the converter of rotation over an interfaced surface of a case of transmission. The nominal rate makes 9.6 mm. |
|
|
|
|
