Mercedes S-Class W-140

1991-1999 of release

Repair and car operation

Mercedes S-Class
+ Mercedes-Benz Cars of a class S (W-140)
+ Operation manual
+ Routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ gear shifting Box
+ Avtomaticheckaya transmission
+ Coupling
+ Brake system
- Suspension bracket and steering
   Security measures
   Corners of installation of wheels of the car, road clearance
   - Forward suspension bracket
      Gap adjustment in the bearing of a forward wheel
      Removal and installation of the bottom spherical support
      Check of a condition of the top spherical support
      Replacement of the top cross-section lever
      Replacement of the bottom cross-section lever
      Removal, check and installation of a nave of a forward wheel
      Removal and installation of assembly of a rotary fist
      Removal and installation of a screw spring
      Removal and installation of the stabilizer of cross-section stability
      Removal and shock-absorber installation
      Regulator of a road clearance of a forward suspension bracket - installation details
   + Back suspension bracket
   + Steering
+ Body
+ Onboard electric equipment

Removal and installation of the bottom spherical support

Removal

PERFORMANCE ORDER

1. Remove a forward wheel.
2. Turn out the lock screw screwed in a brake board.Отдайте an axial nut (7а) the basic hinge of a spherical support.
3. Screw on an axis of the basic hinge of a spherical support a persistent element (044b), delay outside a brake disk with a board and by means of a stripper (044) No. 140 589 09 33 00 separate the basic hinge from a rotary fist.
4. Turn out a hinge nut from the lever.
5. Operating in a similar manner, liberate a spherical support from the suspension bracket lever.
6. In case of need smooth out konusny elements of sharnirny assembly.
7. Estimate a condition of a protective cover (7f) and wire collars (7d and 7h) its fastenings. In case of need make necessary regenerative repair, or replace the failed components / шарнирную assembly.

Installation

Installation is made upside-down.

Tighten самоконтрящиеся nuts of fastening of a support with demanded effort (to a rotary fist: 140 Nanometers, to the lever: 100 Nanometers). The lock screw on a brake board tighten with effort of 22 Nanometers, on a brake disk – with effort of 10 Nanometers.