Mercedes S-Class W-140

1991-1999 of release

Repair and car operation



Mercedes S-Class
+ Mercedes-Benz Cars of a class S (W-140)
+ Operation manual
+ Routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ gear shifting Box
+ Avtomaticheckaya transmission
+ Coupling
+ Brake system
- Suspension bracket and steering
   Security measures
   Corners of installation of wheels of the car, road clearance
   + Forward suspension bracket
   + Back suspension bracket
   - Steering
      Removal and installation of the steering pump (model with engines 104, 119, 120 and 606)
      Dismantling and assembly of the pump of the amplifier of a steering
      Dismantling and assembly of an electronic and adjustable steering column
      Removal and installation of the bottom steering shaft
      Removal and installation of a drive of telescopic adjustment of a steering column
      Removal and installation of an emphasis of a pipe
      Dismantling and assembly of an internal pipe
      Installation of the top arm of fastening of a pipe (model to identification number 123446)
      Installation of the top arm of fastening of a pipe (model from identification number 123447)
      Removal and installation of the blocking cylinder (model till 31.08.95 вып.)
      Removal and installation of the blocking cylinder (model since 1.09.95 вып.)
      Contact spring
      Removal and installation of average steering draft
      Removal and installation of the pendular lever of a steering drive
      Removal and installation of cross-section steering draft
+ Body
+ Onboard electric equipment



56822268



Removal and installation of the pendular lever of a steering drive

Removal

Details of installation of the pendular lever


 PERFORMANCE ORDER

1. Separate from the pendular lever (26) cross-section steering draft (10).
2. Separate from the pendular lever (26) average draft (11).
3. Remove the thermofilter (26h).
4. Give a nut (26b), take the screw (26а) and remove the pendular lever (26) assembled with a bearing ring (26i).
5. Having hooked a screw-driver sealing sponges, take the plug from a bearing ring.
6. By means of a stripper (061) No. 129 589 00 33 00 take a rubber pillow (26f).

Installation

 PERFORMANCE ORDER

1. Installation is made upside-down. The rubber pillow should be planted against the stop by means of the special adaptation (062) of No. 201 589 08 43 00.
2. Correctly adjust the landing size and assemblies of the pendular lever with a bearing ring (and = 22.7 mm).
3. Replace all самоконтрящийся fixture.
4. Самоконтрящуюся a nut of fastening of the pendular lever to the bearing tighten with effort of 120 Nanometers.


At the correct position of the spherical hinge adjusting situation can vary within at most 5 mm.