|
1. Curtail covers of shatunny bearings (1). A rod (2) and a cover (1) are marked together.
2. Remove the piston (4) and a rod (2) up. The direction of movement is beaten out on the top part of the piston. On some versions of the shooter of the direction of movement keeps the visibility not long because of wear of the piston; in this case the direction is necessary for noting again.
3. Vypressuyte by means of a screw-driver a lock ring (5) also remove the piston from a rod.
4. Check gaps of piston rings.
5. Grease a piston finger (6) and the rod plug.
6. Establish the piston (4) on a rod (2).
7. Press by hand a piston finger (6).
8. Insert a lock ring (5) into a groove in the piston.
9. Wipe cylinders, shatunny necks, loose leaves and pistons (4) oil.
10. Establish an opravka (7) on piston rings.
11. Establish pistons (4) in the movement direction.
12. Establish rods (2) and covers (1), having combined lateral labels.
13. Check and tighten bolts of fastening of shatunny necks.
14. After assembly check gaps and ease of rotation. |
