| 1. Check codes of camshafts. The code of a camshaft is beaten out on a neck of the 3rd bearing and on a camshaft flange. |
|
| 2. Establish a cylinder 1 or 6 cam a working ledge up so that it did not press the hydrojack. |
|
| 3. Establish a clamp (02) carving plug (04) on a contact surface of a head of the block of cylinders of a checked camshaft. |
|
| 4. Establish the digital device (01) with shchupy (03) (80 mm) on a clamp (02) on the left side of a checked camshaft. Establish щуп with a preliminary tightness of 3 mm and at an angle 90 ° to the hydrojack. |
|
| 5. Rotate a cranked shaft by means of a key in the rotation direction until the digital device will not show valve lifting on 2 mm. In this situation check a phase of opening of the checked valve on a pulley of a cranked shaft and compare to data in the table provided below. |
