Mercedes S-Class W-140

1991-1999 of release

Repair and car operation

Mercedes S-Class
+ Mercedes-Benz Cars of a class S (W-140)
+ Operation manual
+ Routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
- Gear shifting box
   Specifications
   Removal and transmission installation
   Forward cover of a transmission - installation details
   Removal and installation of a back cover of a transmission
   + РКПП 717.438
   - РКПП 717.454
      Removal and installation of the sensor of speed of the car (VSS)
      Removal and installation of a forward cover of a transmission
      Removal and installation of a back cover of a transmission
      Removal and installation of an intermediate case
      Replacement of an epiploon of a back cover of a transmission
      Removal and installation of shaft of a transmission
      Dismantling and assembly of an intermediate shaft
      Verification of dimensional characteristics of a transmission
      Replacement of conic roller bearings of an intermediate shaft
      Replacement of ball bearings of an intermediate shaft
      Adjustment of the mechanism of gear shifting
+ Avtomaticheckaya transmission
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Adjustment of the mechanism of gear shifting

Details of installation of elements of the mechanism of gear shifting

Design of the mechanism of gear shifting


201 — the Decorative handle 202 — the Casing 203 — the Nut 204 — the gear shifting Lever 206, 221 — Springs 204, 226 — Lock rings 218, 211 — Plugs 209, 225, 279 — Fingers 310 — a switching Fork	213, 227, 233 — Bolts 216 — a bearing Cover 218, 220, 239, 240 — Laying 224 — the Lock eye 230 — the Arm of bearings 231 — the Lock plate 230 — Plastic laying 236, 237, 238 — Intermediate levers of switching

PERFORMANCE ORDER

1. Establish the lever of gear shiftings in neutral situation, then disconnect switching levers from drafts of switching on the gear shifting mechanism after removal of lock clips (37).
2. Arrange three intermediate levers in the following sequence: transfer back the хода/1st transfer, the 2/3rd transfers and the 4/5th transfer also block them a lock finger through openings.
3. Weaken lock nuts (arrows) and adjust length of each draft.
4. Remove a lock finger from intermediate levers of gear shifting. 5. Check gear shifting at the working engine.