Mercedes S-Class W-140

1991-1999 of release

Repair and car operation



Mercedes S-Class
+ Mercedes-Benz Cars of a class S (W-140)
+ Operation manual
+ Routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ gear shifting Box
- Автоматичеcкая transmission
   Specifications
   Search of malfunctions - the general information
   - Automatic transmission 722.5
      Removal, check of a condition and installation of the converter of rotation (hydrotransformer)
      Removal and installation of a centrifugal regulator
      Removal and installation of the sensor switch of blocking of a starter (start permission)
      Vacuum knot - installation details
      Removal, service and installation of the secondary pump (AT to No. 3652931)
      Removal and installation of a forward cover with the secondary pump
      Removal and LB3 piston installation
      Removal and installation of a back cover of transmission
      Dismantling and assembly of klapanny assembly of AT
      Dismantling and transmission assembly
      Installation and gap check in multidisk brake В3
      Gap measurement in brake В1
      Coupling of raising transfer
      Removal, installation and check of components of a brake of BS of raising transfer and KS coupling
      Dismantling and assembly of the coupling of a free wheeling
      Dismantling and assembly of planetary mechanisms
      Dismantling and assembly of coupling К1
      Coupling К2
      Lever of the selector of gear shifting
   + Automatic transmission 722.6
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment



56822268



Removal and installation of a centrifugal regulator

Removal

Details of installation of a centrifugal regulator


 PERFORMANCE ORDER

1. Lift transmission.
2. Remove a cross-section beam of the engine (19). Remove an arm (10) exhaust pipes and a bracket (11), having unscrewed nuts (7).
3. Remove a guard (5).
4. Disconnect the forward driveshaft (71) from a transmission.
5. Disconnect an exhaust pipe (60) from a back support.
6. Unscrew a shaft of a speedometer (9) or the inductive sensor (85a).
7. Press a cover (46) and remove a lock ring (43) and a sealing ring (48).

8. Turn a flange so that the centrifugal regulator (50) was established in the situation shown on an illustration.
9. Insert nippers, compress a lock ring (43) and remove a regulator (50).

Installation

 PERFORMANCE ORDER

1. Turn a transmission to the right and insert a regulator (50) by means of nippers (072).
2. Insert an ear (shooter) into a flute in the regulator case. Be convinced that the lock ring is blocked in a flute. If the regulator is established correctly, the lock ring can rotate in a flute easily.
3. Check a condition of a sealing ring (48) and if it is necessary, replace it.