|
1. Remove a drain stopper (4a) and merge ATF.
2. Lift a transmission.
3. Remove a cross-section beam of the engine.
4. Unscrew back support of the engine.
5. Remove an arm (10) systems of release and a bracket (11), having unscrewed nuts (7).
6. Disconnect system of release (60) from back support.
7. Unscrew the forward driveshaft (71) from a transmission.
8. Remove a centrifugal regulator (50).
9. Having unscrewed a shaft of a speedometer (9) or the inductive sensor (85a).
10. Remove a flange (64).
11. Remove laying (65).
12. Remove the secondary pump (see. The section Removal, service and installation of the secondary pump (AT to No. 3652931)).
13. Unscrew a bolt (73).
14. Remove a back cover of a transmission (70). Laying (72) can be established several times if to establish it without hermetic.
15. Establish laying (163) on a target shaft.
|
